• DSC NEO PowerG Belaidis Dūmų Detektorius PG8926
  • DSC NEO PowerG Belaidis Dūmų Detektorius PG8926

Prekės kodas: PG8926

Turimas kiekis: Pristatymas iki 14 d.d.

Belaidis dūmų jutiklis. Fotoelektrinis sensorius, Informuoja apie dūmus, tamperį ir silpną bateriją, Matomas ryšio kokybės indikatorius, Pilnai stebimas, Baterijos indikatorius, Įstatytas 85dB garsiakalbis

€90.18

PG8926 smoke detectors provide open area protection and early warning of developing fires by:

• Activating a fire alarm upon a smoke condition.
• Sounding an alarm with its built-in alarm horn.
• Transmitting a coded alarm signal to a compatible wireless 

Detector type: Photoelectric

Alarm Sound Level: 85 dB at 3 m (10 feet)
Frequency Band (MHz) - CE Listed PG4926: 433MHz; PG8926: 868MHz; FCC/IC/UL/ULC listed PG9926: 915MHz Communication Protocol: PowerG
Tamper Alerts: Tamper event (removal of the unit from its bracket) is reported once. Tamper restore is reported when the tamper switch is restored
Alarm Report: In the alarm condition, the detector sends the alarm event to the control panel. When the alarm condition is restored, the detector sends an alarm restore event to the control panel and sets the alarm restore indication (red LED blinks once per sec.).
Note: The alarm restore indication can be cleared via the control panel only.
Power Source: 3 Volt CR123A consumer grade / CR17450 lithium industrial grade. CR17450 not tested by UL. Operation Voltage: From 2.5 V to 3 V.
Current Drain: 22 μA standby, 200 mA max. in operation Smoke Density: Europe: 0.09 – 0.14 dB/m
USA: 1.44%/ft to 2.74%/ft
Cover Range :50 – 100 cubic meters (1770 – 3530 cubic ft.) Battery Supervision: Automatic transmission of battery status data as part of any transmitted message.
Low Battery Threshold: 2.5 V
Audible and Visual Low Battery Warning: Built-in horn beeps every 30 seconds simultaneously with red LED flashing (for up to 30 days when the battery voltage drops).
Audible and Visual Degraded Chamber Sensitivity Warning: Built-in horn beeps every 30 seconds in the middle of red LED flashing intervals – indicates that the detector must be replaced.
Clean Warning Transmission: A clean (maintenance) signal is transmitted when the detector's chamber becomes stained, causing the detector to operate at high sensitivity. 

Temperature range: -10°C to +55°C (UL/ULC verified 0° to +49°C)
Relative Humidity: max. 93%RH, non-condensing (UL/ULC verified max 85%RH)

Dimensions: 120 mm (4.7") x 58 mm (2.3")

COMPATIBLE RECEIVERS

433MHz Band: HSM2HOST4; HS2LC- DRF(P)4;HS2ICN9RF(P)4; PG4920
868MHz Band: HSM2HOST8; HS2LCDRF(P)8; HS2IC- NRF(P)8;PG8920
912-919MHz Band: HSM2HOST9; HS2LCDRF(P)9; HS2IC- NRF(P); PG9920

Rašyk
Skambink